Software Settings Questions
It provides assistant software (app) for iOS devices, you can download these from the APP store, and you also need the DJI Bluetooth LED.
The assistant software for Mac will be available in the future.
- Use the 1.36 version assistant software to update the firmware to the corresponding version.
- Use the 1.36 version assistant software to import the configuration file.
- Then use the latest version assistant software to upgrade the firmware.
- Check the parameter settings according to the actual circumstance of your aircraft and test flight.
- Download the 1.36 version assistant software and the configuration file.
- Some of the users who use WINDOWS 7 operating system may not have the usbser.sys file, please download this file and put it into C: \ WINDOWS \ system32 \ drivers, and then reinstall the driver.
- Download the usbser.sys file.
If you fail to adjust the gain value in the Assistant software, please check the follow items to solve the problem:
1. Make sure the MC has connected and communicated with the Assistant software successfully.
2. Make sure the Receiver has connected to the MC successfully.
3. Make sure you have selected the correct Receiver type in the Assistant software, and then you can try to adjust the gain value again.
Hardware Install Questions
Please check the following items:
a). Whether the aircraft or motor is overloaded or not, which could cause the aircraft to lose altitude;
b). Whether the battery power is sufficient, low voltage will trigger the low voltage protection function;
c). The vibration of the aircraft is excessive, please check the motors and propeller balance to avoid vibration;
Basics
“This is the Home-Point indicating function. When the Home-Point has been recorded before takeoff, every time the main controller has searched more than 6 satellites (no red flashing), and you are not in manual mode, the LED will flash 6 purple LED’s periodically to indicate that the aircraft is less than 8km from the Home-Point. When the aircraft is outside the 8km radius, the LED’s will cease blinking.
If you are using the IOC function, every time you re-edit the Home-Point, the purple lights will flash.
LED blinks yellow and green alternatively means compass errors or interference:
1.Long time yellow and green blinking: in this case compass calibration is required.
2.Temporary yellow and green blinking: e.g. LED blinks several times when the aircraft flying over some district and then no yellow and green blinks; or take an calibrated aircraft from outside to inside of house, the yellow and green blinking may appear inside. In these cases the compass is ok and has no influences to flight. Compass calibration is not required.
When compass data become abnormal (LED blinks yellow and green) during flying, for safety reasons, the autopilot system will auto change the control mode. However in ATTI. and Manual Mode is free from influence. In any other control mode, the autopilot system will enter into ATTI. Mode automatically (the mode shown on status bar will be “Atti.” if you connect the autopilot to the assistant software). Once the compass data go back to normal, the autopilot system will regain the original control mode.